Spike
Monday, April 13, 2020
FINISHING THE TRIKE SPINDLES / KNUCKLES
Finished the Chevette/Fiero knuckles for the trike. I decided to remove the backing plates, but I will keep them, just in case. Packed and installed the bearings, along with the rear seal. I went with the chevette dics, for the 4 x 100 bolt pattern. Which will be helpful when it comes time to bolt up the Triumph 15 inch wire wheels and hubs.
Spike
Spike
Subscribe to:
Post Comments (Atom)
-
This is the final post on front suspension for now, I made and welded new top wishbones. I also changed the upper and lower ball joint. all... -
Today I made the jig for the front wish bones, cutting an offset for size difference of the bushing tube. Then I made some mock upper and lo...
No comments:
Post a Comment